Appendix A - Technical Characteristics; Summary Table - Mocom millwashing Manuel D'utilisation

APPENDIX A – TECHNICAL CHARACTERISTICS

SUMMARY TABLE

Unit
Model
Manufacturer
Power supply voltage
Mains frequency
Dimensions (L x D x H)
Nominal power
Insulation class
Installation category
Environment of use
Environmental operating conditions
Net weight
Dimensions of the chamber (W x D x H)
Max load of materials
Pressure of incoming water
Available cycles
Water softener (resins)
Detergent dispenser
Additive dispenser (option)
Detergent consumption
Additive consumption
Instruments washer and thermo-disinfector
M.O.COM. Srl
Via Saliceto, 22
40013 Castel Maggiore (BO)
220/230 Vac (other voltages upon request)
50 Hz
560 x 600 x 555 mm (with closed door)
2750 W
Class I
Cat. II
Indoors
Temperature: +15°C ÷ +35°C
Relative humidity: 80% (max), non condensing
Altitude: 2000 m upon sea level.
about 44 kg
400 x 470 x 260 mm
8 kg
Min 250 kPa (2,5 bar) – static pressure
200 kPa (2,0 bar) – dynamic pressure
Max 500 kPa (5,0 bar) – static pressure
400 kPa (4,0 bar) – dynamic pressure
3
Embedded (regeneration to be carried out by user)
Programmable water softening rate (according to water hardness)
500 cc
500 cc
18 cc/cycle (average value) – configurable value
3 cc/cycle (average value) – configurable value
Italy
15