Table des Matières
Publicité
4. SIGNIFICATION DES SYMBOLES SUR LES ÉTIQUETTES
5. USA FCC-Regulatory Information (2,4 GHz radio module)
This equipment has been tested and found to comply with the limits for a digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1)
this device may not cause harmful interference, and
2)
this device must accept any interference received, including interference that may
cause undesired operation
WARNING:
Changes or modifications made to this equipment not expressly approved by IMET may void
the FCC authorization to operate this equipment.
RF EXPOSURE NOTICE:
The radiated output power of this device is below the FCC radio frequency exposure limits.
Nevertheless, the transmitters shall be used in such a manner that the potential for human contact
during normal operation is minimized.
IMET – M880 ALL FR v. 3.9.docx
Équipement Classe II
Pour identifier les équipements conformes aux normes de
sécurité spécifiques pour les appareils de classe II selon
Tension dangereuse
Pour indiquer les risques découlant des tensions
dangereuses
Courant continu
Pour indiquer que l'appareil est
adapté au courant continu ; pour identifier leurs
Courant alterné
Pour indiquer que l'appareil est
adapté au courant alterné ; pour identifier leurs
Ne pas utiliser de l'eau à haute pression
Pour indiquer de ne pas nettoyer avec un puissant jet
Usage à l'intérieur
Pour indiquer l'usage à l'intérieur
IEC 60536
terminaux
terminaux
d'eau
9/68
Hide quick links:
Publicité
Table des Matières
