Cetetherm Micro 2000 Manuel page 16

RELAYS' AFFECTATION
You can change the different relays' affectation if you have at least 1 free relay. This can
be used on all models, except Semi instantaneous Double / Double (no free pump
relay).
If you change a pump relay, don't forget to change others (to avoid P1 on R2 and P2 on
R2 too...).
You may have many possible combinations. Then you can manage if you have
damaged relay(s) or fuse(s).
Primary pump 1 activated by P1 relay of power board.
Press + or – to change relay affectation.
Please note each relay's affectation to avoid hasardous
situations like 2 different pumps activated with the same relay ! or
no relay for a forgotten pump... !
Press  yellow (rep. 4 key).
Primary pump 2 activated by P2 relay of power board.
Press + or – to change relay affectation.
Please note each relay's affectation to avoid hasardous
situations like 2 different pumps activated with the same relay! or
no relay for a forgotten pump...!
Press  yellow (rep. 4 key).
Secondary pump 1 activated by P3 relay of power board.
Press + or – to change relay affectation.
Please note each relay's affectation to avoid hasardous
situations like 2 different pumps activated with the same relay! or
no relay for a forgotten pump...!
Press  yellow (rep. 4 key).
Secondary pump 2 activated by P4 relay of power board.
Press + or – to change relay affectation.
Please note each relay's affectation to avoid hasardous
situations like 2 different pumps activated with the same relay! or
no relay for a forgotten pump...!
Press  yellow (rep. 4 key).
Default language, even after a RESET.
Press + or – to set. Pressing  yellow (rep. 4 key) will loop
this menu.
At any time, you can interrupt the setting procedure and memorize
the changes by pressing the OK key.
To memorize your modifications, Press + for YES and – for NO
ANY PARAMETER MODIFICATION SHOULD BE VALIDATED THIS WAY
SAVE MODIFICATIONS
Page 16 / 24
.