Cetetherm Micro 2000 Manuel page 14

Once the TWH is configurated according to the type of pumps fitted on the primary and
the secondary, the temperature parameters may require to be adjusted.
We recommend the parameters' values entered at the factory are not modified
Normal set point value in operation. Do not change for
standard unit.
If required, adjust by pressing + or - keys.
Reminder: Swimming pool = 27°c
Press  yellow (rep. 4 key) to continue.
Reduced temperature set point Do not change for standard
unit.
If required, adjust by pressing + ou - keys.
Reminder: Swimming pool
Press  yellow (rep. 4 key) to continue.
Low temperature alarm.
Temp. difference between set point & actual low alarm
temperature
Do not change for standard unit.
If required, adjust by pressing + ou - keys.
Reminder: Swimming pool = 2°
Press  yellow (rep. 4 key) to continue.
High temperature alarm.
Temp. difference between setpoint & actual high temperature
alarm.
Do not change for standard unit.
If required, adjust by pressing + ou - keys.
Reminder: Swimming pool = 2°
Press  yellow (rep. 4 key) to continue.
To reverse the 0-10 volts signal to the actuator for cooling
systems, set to YES by pressing + or - keys.
Do not change for standard unit !! Risk of enjury !!
Press  yellow (rep. 4 key) to continue.
nd
The 2 default relay can be attributed to high alarm (in standard)
or activated while thermal treatment function is running.
Do not change for standard unit.
If required, adjust by pressing + ou - keys.
Press  yellow (rep. 4 key) to continue.
At any time, you can interrupt the setting procedure and
memorize the changes by pressing the OK key.
To memorize your modifications, Press + for YES and – for NO.
ANY PARAMETER MODIFICATION SHOULD BE VALIDATED THIS WAY
27°c (no reduction)
=
SAVE MODIFICATIONS
Page 14 / 24