Ii- Software Version; Iii- Factory Menu 1 - Cetetherm Micro 2000 Manuel

II- SOFTWARE VERSION

When switching unit on, the display shows the following information:
Date of updating of the software

III- FACTORY MENU 1

Access the factory menu by pressing the following keys:
Display shows:
Press + key and follow the instructions below:
Instructions and comments
Press the + key until the right pump combination is displayed.
Once the right pump combination is selected, press  yellow (rep.4) to
continue. The possible configurations are as follows:
Instantaneous with Double primary pump + 2 Recycling pumps
Semi Instantaneous Double primary pump and Double second. pump
Instantaneous Double primary pump + 1 Recycling pump
Semi Instantaneous Double primary pump and Single second. pump
Instantaneous Single primary Pump +2 Recycling pumps
Semi Instantaneous Single primary pump and Double second. pump
Instantaneous Single primary pump + 1 Recycling pumps
Semi Instantaneous Single primary pump and Single secondary pump
Instantaneous with Single primary pump
Instantaneous with Double primary pump
Should you miss the right configuration, Press + key until the right one.
Or
Press  yellow (rep. 4 key) to set other parameters.
FOR 3 SECONDS (same line keys)
OR
OR
OR
OR
Page 13 / 24
Software Version
display