Plantronics CA10 Guide D'utilisation page 12

CA 10Gray2 Body.r2 12/12/01
AUDIO VISUAL PROMPTS
VISUAL
REMOTE
Talk (In-Use) — Green LED. On only when Remote or Base
Unit TALK button is activated. Flashes in time with telephone ringer
when optional Handset Lifter (see Accessories) is used.
Mute — Red LED. On only when transmit audio is "muted."
BASE
Power — Red LED. On whenever power is applied to the Base
via the AC Power Adapter.
Talk (In-Use) — See above.
Charge — Amber LED. Flashes for 2 seconds while verifying
contact when Remote is placed in Base Unit Charging Well.
Remains steady while charging, off when battery is fully charged.
AUDIO
Low Battery — Two (2) beeps generated at 30 second
intervals whenever power is low, heard only through the headset
in TALK mode.
Out-of-Range — Three (3) beeps generated whenever the
Remote is taken out-of-range of the Base, heard only in TALK
mode through the headset.
Linked — One (1) beep heard through the headset whenever
the Base or Remote Unit TALK button is activated.
Ringer Tone Alert — (Can be activated when using optional
Handset Lifter)
Tone emitted by Remote timed with telephone ringer; can be
disabled using Ringer Switch on Remote. (Note: Disabling the
audible ringer does not disable the Page Function or the ringing
heard through the headset.)
6:50 PM Page 10
10
TROUBLESHOOTING
I CANNOT HEAR A DIAL TONE
Make sure your Remote Battery Pack is securely seated in the
Charging Well and/or fully charged. The Battery Pack must
charge for 8 hours prior to first use.
Check that all cords are correctly connected and firmly in place.
Pay special attention that Handset and Telephone cords are
properly connected.
Adjust the Listen Volume Control .
10
Make sure the Remote Unit is within range of the Base Unit.
Make sure the handset is off-hook.
Separate and then reconnect the Battery Pack and Remote Unit.
Return the Remote to the Base Unit charger for 5 seconds to
re-establish a communication link.
MY REMOTE STOPPED WORKING
Separate and then reconnect the Battery pack and Remote Unit.
Remove and replace the AC power cord from the Base Unit.
Return the Remote Unit to the Charging Well for 5 seconds to
re-establish a communication link.
CALLER CANNOT HEAR MY VOICE
Make sure the Mute Button is off.
9
Make sure Transmit Level Switch is in position 1 or 2.
20
Adjust the Talk Volume Control .
16
Adjust headset so the voice boom is closer to your mouth.
11
C
G
A
C
A
C