Panasonic ES7024 Manuel D'utilisation page 4

9
j
a c
b k
6
g
f
h
d
e
i
Parts identification
(see fig. 1)
A Protective cap
B System outer foil
C System outer foil release but-
tons
D Foil frame
E Inner blades
F Foil frame release buttons
G On/Off switch
H Low battery indicator
I Charge status lamp
J Trimmer
K Trimmer handle
L Power cord
READ ALL INSTRUCTIONS BE-
FORE USE.
Charging and cordless
shaving
(see fig. 2)
When charging the shaver for the first
time or when it has not been in use
for more than 6 months, charge it for
at least 8 hours before use.
Connect the power cord to the
shaver, and plug the power cord to
an AC outlet.
In some areas, a special plug adap-
tor may be required.
The charge status lamp will glow
when the shaver is being charged. It
will flash when the charging is com-
pleted.
You can fully charge the shaver in 1
hour if the low battery indicator glows.
A full charge will supply enough
power for approx. 12 shaves (3 min-
utes per shave for a normal beard).
Cord shaving
Connect the shaver to the AC outlet
and turn the shaver on.
If the shaver does not run, charge it
for approx. 1 minute.
Using your shaver
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (see fig.
3). Start out shaving by applying gen-
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
System outer foil
(see fig. 4)
System outer foil has a slit blade (a)
between 2 foils (b). They move up
and down independently to follow the
contours of your face.
The slit blade catches and cuts
longer and lying hairs easily.
Using the trimmer
(see fig. 5)
Slide the trimmer handle up to open
the trimmer.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
7
7