Additional Information - D-Link DGS-1024C Guide D'installation Rapide

Installing a Power Cord
Retainer (For DGS-1024C)
Installation of a power cord retainer is recommended
to prevent accidental removal of the AC power cord.
A. Insert a tie wrap with the rough side facing down
into the hole below the power socket.
Insert tie wrap
B. Connect the AC power cord into the AC power
inlet of the switch.
Connect the power cord to the switch
C. Attach the retainer to the tie wrap and slide it up to
the end of the cord.
Attach the retainer to the tie wrap
D. Wrap the retainer around the power cord and
place the free end into the fastener.
Wrap the retainer around the power cord
E. Fasten the retainer by pulling on it until secure.
Secure the power cord
F. Connect the AC power cord to an electrical outlet.

Additional Information

Additional help, product and warranty information
is available online at support.dlink.ca (CAN) or
support.dlink.com (USA).
©2018 D-Link Corporation. All rights reserved.
Trademarks or registered trademarks are the property
of their respective holders. Software and specifications
subject to change without notice.
3