Initial Operation; Decalcification And Cleaning - EFBE-SCHOTT SC KA 1080.1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fax +32 2 359 95 50
-
-
-
-

INITIAL OPERATION

When you use your appliance for the first time, pour fresh water into the water tank and switch
on the appliance (without coffee).
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough, repeat the process with fresh water. Repeat this process 3 times.
PREPARATION OF COFFEE
Open the lid of the water tank.
Pour the desired amount of water into the water tank. Make sure not to overfill by
respecting the maximum level indicated on the water tank.
Remove the glass jug from the hotplate. Swing the filter holder, insert a paper filter or
permanent filter (depending on the model) in the filter holder and add the desired
quantity of ground coffee (1 teaspoon per cup, approximately 6g). Please note: fold the
bottom and the side edges of the paper filter in such a way that it fits perfectly in the filter
holder. Replace the filter holder, making sure it is placed correctly. Always put the filter
holder back into place before putting the jug on the hotplate, otherwise the anti-drip
system will disturb you when doing so.
Never forget to close the lid of the jug before putting the jug on the hotplate.
Never forget to close the lid of the water tank before switching on your coffee maker.
Switch on the coffee maker. The pilot light of the switch will be illuminated, indicating that
your appliance works. Make sure that you never let an empty jug on the appliance.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
Thanks to the keep warm function, your coffee is warmed up as long as the appliance is
switched on and the jug is standing on the appliance.
Please note: After brewing the machine remains switched on for 35 minutes before it
automatically turns off completely.
If you wish to cook coffee several times in succession you proceed as follows.
Switch on the machine, wait until the brewing process is completed. Then turn off the
machine. Wait 10 seconds.
Now you can make coffee again.

DECALCIFICATION AND CLEANING

Before cleaning, turn off the appliance, unplug it and let it cool down.
The filter holder, carafe and carafe lid can be cleaned in a solution of warm water and
mild liquid soap.
The coffee maker can be cleaned using a damp cloth. Never immerse the body of your
coffee maker in water or any other liquid. Never use abrasive cleaning products or
solvents.
Decalcifying the coffee maker prolongs its life span. For decalcification only use products
especially made for the decalcification of coffee makers.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Kitchen corners reserved for personnel in shops, offices and other
professional environments.
Farms.
The use by clients of hotels, motels and other environments with a residential
character.
Environments of the "bed and breakfast" type.
Back cover page (last page)
Assembly page 11/23
11
SC KA 1080.1 – 180123

Publicité

Table des Matières
loading

Table des Matières