Liability Exclusion; Operating Elements - Renfert Vario E Instructions Originales

3.2 Safety Information
► The Vario E is an electrical device with potential hazards. This unit may only be locked and used
by authorized specialist personnel after an examination with regard to conformity with applicable
EN
national standards.
► Before starting the unit, compare the information on the nameplate with the specifications of your
local power supply.
► Do not operate the unit with damaged power cords or other defects.
► During operation, always unroll the power cord (overheating hazard in case of a short circuit).
► Liquid waxes can cause burns. Do not move the unit during operation!
► During operation, the wax pots are heated up to their rims. Improper use or handling can result in
burns even approx. within 30 minutes after power off.
► The Vario E is designed to be used exclusively in conjunction with commercially available dental
waxes. Never use the unit to heat other types of materials!
► Please note: Overfilled pots can spill over!
► Do not use this device with materials whose flash point is below 175 °C (347 °F). Keep away any
flammable materials from the hot surface of device.
► Do not rinse or dip into water. Hazardous voltage can cause electric shock!
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702 (As-
sociation for Electrical, Electronic and Information Technology).
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
3.3

Liability Exclusion

Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions;
► The product is altered in any way other than those alterations described in the operating instructions;
► The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed;
► The product continues to be employed, despite obvious safety faults;
► The product is subjected to mechanical jarring or is dropped.
4

Operating Elements

A) On / Off switch
B) Wax pot selection button
C) LED indicator for the selected wax pot
>> Operation indicator = green
>> Warm-up phase = red
D) Set-point temperature increase
E) Set-point temperature decrease
F) Setpoint / actual temperature display
G) Wax pot
H) Lid
I) Power cord
(Figure 1a + 1b)
- 2 -