Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When the unit is first powered on it will display the software version number for approximately 3 seconds then flash the
LED's, report any errors and then the current flow reading. From this point the menu structure below can be accessed.
The menu structure is divided into three sections
•
General viewing level
•
Set up level
•
Factory menu
The factory menu is for trained Webtec service personnel only. To enter the
set up level menu requires a password - the default password for this is '11'.
Menu structure - General viewing level
On this level it is possible to view the values which have been set.
According to the model purchased, features will vary and therefore may
not be available as described.
Press and hold the
return to the current reading.
Press and hold the
reading and the temperature units - release the key to return to the current
reading.
Press the
key to view the current switch settings.
- Switch one - delay time in milli seconds
- Switch two - delay time in milli seconds
- Switch one - flow level in default engineering units
- Switch two - flow level in default engineering units
6
6
to display the engineering units - release the key to
to alternate the display between the temperature
*
* This additional level only will be shown on
ViscoCorrect version.
Publicité
Table des Matières
