Others; Display Brightness; Auto Off Function - Technics SL-C700 Manuel D'utilisation

Others

Display brightness

The brightness of this unit's display and the basic control
switches can be changed.
≥ Operation with the touch panel on the unit:
1
Touch [MENU] repeatedly to select
"Dimmer".
2
Touch [:, 9] to select an item and
then touch [1/;].
≥ When using the SU-C700/ST-C700 remote control, press
[DIMMER] to select the brightness.
≥ When the display is turned off, it will light up only when you
operate this unit.
Before the display turns off again, "Display Off" will be displayed
for a few seconds.
Operation sound setting
You can turn the beep sound on/off.
≥ The factory default is "On".
≥ Operation with the touch panel on the unit:
1
Touch [MENU] repeatedly to select "Setup"
and then touch [1/;].
2
Touch [MENU] repeatedly to select "Beep".
3
Touch [:, 9] to select an item and
then touch [1/;].
4
Touch [∫] twice after you have finished
setting.
≥ Operation with the SU-C700/ST-C700 remote control:
1
Press [CD].
2
Press [MENU].
3
Press [3, 4] repeatedly to select "Setup"
and then press [OK].
4
Press [3, 4] repeatedly to select "Beep".
5
Press [2, 1] to select "On"/"Off" and then
press [OK].
6
Press [MENU] after you have finished
setting.
14
(14)

Auto off function

This unit is designed to conserve its power consumption and
save energy. The unit will turn to standby mode automatically
if there is no sound and it is not being used for approximately
20 minutes.
≥ The factory default is "On".
To cancel this function
≥ Operation with the touch panel on the unit:
1
Touch [MENU] repeatedly to select "Setup"
and then touch [1/;].
2
Touch [MENU] repeatedly to select
"AUTO OFF".
3
Touch [:, 9] to select an item and
then touch [1/;].
4
Touch [∫] twice after you have finished setting.
≥ Operation with the SU-C700/ST-C700 remote control:
1
Press [CD].
2
Press [MENU].
3
Press [3, 4] repeatedly to select "Setup"
and then press [OK].
4
Press [3, 4] repeatedly to select
"AUTO OFF".
5
Press [2, 1] to select "Off" and then press
[OK].
≥ To enable the output again, select "On".
6
Press [MENU] after you have finished setting.
≥ The auto off function works unless you turn it off, even if you turn
off and on this unit.