Instruction For Use - AnMo Electronics Dino-Lite Mode D'emploi

9. INSTRUCTION FOR USE

a) Put the part to be observed below and in the center of the illuminated area of your
Dino-Lite microscope
b) It is advisable to start working at minimum magnification (turn the wheel of the
microscope until the arrow matches 20x). Place the microscope at a distance
greater than 3cm from the subject to enlarge
c) Slide under the cover/optic the subject you wish to see in order to visualise the area
d) Turn the wheel of focus to maximise viewing and have a sharper image
e) To use the microscope at a magnification between 20x and 50x, move progressively
the cover closer to the surface of the subject and proceed to enlarge the focus as in
the preceding paragraph
f) To use the microscope at a magnification of 200x it is necessary to bring the cover
of the microscope in contact with the subject, then using the wheel to focus on the
object
g) Always use the procedures described above, being careful that the lenses are not in
direct contact with the part to be observed
h) Click on "capture" and then on "image" or "video" from DinoCapture software to
take the picture that interests you or to start recording video
N.B. For optimal use of the microscope without support grip the device between thumb
and index accommodating it in the palm of the hand and using your thumb to rotate the
wheel of focus. The tool can be rotated on its axis in order to achieve the rotation of the
image on the screen.
Figura 1 Figura 2
11
Figura 3