Table des Matières
Publicité
Process pressure limit :
- for use of original E+H process connections (See »Accessories« on page 12) max.
16 bar at 20 °C (68 °F)
Installation area/Installation angle: (see figure below)
- Pos. a: At angle sections, against the direction of flow
- Pos. b: In smaller pipes, turned against the direction of flow
- Pos. c: Perpendicular to the direction of flow
Safety instructions:
The unit must only be powered by a power supply that operates using an IEC61010-1
compliant energy limited circuit.
e
8
Publicité
Table des Matières
