SIGNIFY Stonco KEENE PT50 Instructions D'installation page 2

PT50
Operation Options
Installation Instructions
4
To adjust output wattage, remove all four
#8-32 x 3/8" set screws from Wireway
cover with a Phillips screwdriver as seen
in Figure 4.
Figure 4
4X #8-32 X 3/8"
phillips screw
11/18/2019 page 2 www.stonco.com
LED Post Top Installation Instruction
PHOTOCELL OPTION
This operation enables the light fixture to automatically turn ON when dark outside and turn OFF when the
sun rises.
• To enable dusk-to-dawn operation, remove temporary black label cover and ensure the photocell has no
cover on it and is unobstructed.
• Ensure the switch powering the outlet connected to the light fixture is always turned to the ON position
and leave it ON to enable dusk-to-dawn functionality to operate automatically.
TIP: To test if the light fixture and photocell works properly, run power to the fixture and cover the photocell
to turn fixture ON. Shine a light into the photocell to see if fixture turns OFF.
NOTE: If photocell is in an area under heavy shade, the photocell may not detect enough light and may turn
the light fixture ON.
TROUBLESHOOTING
5
Position FAO (Field Adjustable Output)
to desired level between 54W down to
22W as seen in Figure 5.
www.keene-lighting.com
Figure 5
6
Tighten down all four #8-32 x 3/8" screws
provided to 16in-lbs (1 ft-lb); ensuring gasket,
screws, and O-rings are all in place. Restore
power at circuit break and switch on power.
Figure 6
PN 442295136631 Rev C