Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE HOOD
Note: On stainless steel hoods, carefully remove all foam packaging and the plastic
protective film from all exterior surfaces of the hood and decorative flues, prior to final
installation.
1. Pick out the hood from the carton.
2.
Install the vent into the duct connector of the range
hood by 4pcs 4*8MM screws.
3.
Install the flexible aluminum duct (use cable tie if
required)
7
4PCS 4*8mm
Publicité
Table des Matières
