Quick Start - Blyss EL1716B Mode D'emploi

The controls
MASTER POWER SWITCH (A)
- Open the cover and push button A down (I) to "ON" position or push but-
ton A down (O) to "OFF" position.
STANDBY ( )
- Press button
Default interface displays as following :
Setting" to set the time.
.Two short beeps that increase in pitch sound when switched on and
three beeps that decrease in pitch sound when switched off.
.When switches on, the heating level, set temperature and clock icon
are displayed. The display will be disappeared after 60 second without
any operation. Press any button to display again.
LOCKING THE BUTTONS (
- Long press button  for 6 seconds to unlock the buttons.
.Please note the button
to start or stop the flame effect.
- The heating icon
when the room temperature is less than the default
setting (10°C), on the contrary it will not display and
heat.
- The clock icon
time is not set yet. Please follow the steps in "Time

)
- Press and hold button
onds to lock or unlock the buttons, "LOC" is
displayed and indicated that the buttons are
locked. Once it's locked "LOC" will be flashing for 6
seconds then disappear, press any button "LOC"
will flash again.
is never locked.
8
OK
MENU
A
will display and start heating
will be flashing because the

for more than 6 sec-

Quick start