Changing The Filter - LaserLiner AirBreeze 510UV Mode D'emploi

5
Fitting the filters before the device is used
for the first time
1. P ut the air purifier on a flat surface and remove all
packaging.
2. R emove the filter cover by pulling the tabs on the top (a + b).
3. R emove the pre-filter, the HEPA13 filter, and the activated
carbon filter in that order by pulling the tabs (d) provided
for this purpose.
4. Remove all packaging from the filter.
5. R efit the activated carbon filter, HEPA13 filter, and pre-filter
(c). Make sure the pre-filter is firmly seated at all six locking
points.
6. R efit the filter cover in the lower openings. Push the filter
cover carefully forwards into the locking points until is if
firmly seated (e).
6

Changing the filter

1. A flashing Display button (13) indicates the filter is due
for replacement.
2. Switch off the air purifier and disconnect from the mains.
3. R emove the filter cover by pulling the tabs on the top (a + b).
4. R emove the pre-filter, the HEPA13 filter, and the activated
carbon filter in that order by pulling the tabs (d) provided
for this purpose.
5. R emove all packaging from the new filter before installing.
6. F it the activated carbon filter, HEPA13 filter, and pre-filter (c).
Make sure the pre-filter is firmly seated at all six locking
points.
7. R efit the filter cover in the lower openings. Push the filter
cover carefully forwards into the locking points until is if
firmly seated (e).
AirBreeze 510UV
a
c
d
e
b
19
EN