Changing The Filter - LaserLiner AirBreeze 120 Mode D'emploi

6

Changing the filter

1. A flashing Filter reset button indicates the filter is due for replacement.
2. Switch off the air purifier and disconnect from the mains.
3. R emove the filter cover (3) on the underside of the device by rotating the tab (1) to the left and removing
the filter cover.
4. Remove the old HEPA13 filter (2) from the device.
5. Remove packaging from the new HEPA13 filter.
6. Insert the new HEPA13 filter into the device.
7. Refit the filter cover onto the device and rotate the tab to the right until it can go no further to fix it in place.
8. Press the Filter reset button for 3 seconds until the symbols are all lit and are not flashing.
7
Aromatherapy function
There are two sponges (a) in the filter cover. You can
add a few drops of the scent of your choice to the
sponges. When switched on, the device distributes
the scent with the air flow to create a pleasant atmo-
sphere. There is also an option for using your own
scent pearls. Remove the sponges and replace them
with the scent pearls.
Information on maintenance and care
Clean the housing with a damp cloth and do not use cleaning agents, scouring agents and solvents. Cleaning
and/or maintenance work may only be carried out when the device has been disconnected from the mains.
Protect the device from contamination and damage and store in a dry place.
16
EN
a
a Two sponges
to add scents
a