Publicité
Les langues disponibles
Les langues disponibles
STEP 7
POLY PIPE VS PVC
• If using poly pipe, thread
the plastic barbed fitting to
the other side of the braided
stainless steel flex hose. If
using pvc, use the MPT x slip
fitting.
STEP 8
CONNECT IRRIGATION LINE
• Connect a 1/2" irrigation
line to the barbed fitting and
tighten with the hose clamp
provided in the water fill valve
kit.
Adjusting the Water Fill Valve
• Initial positioning of fill valve arm can be made by loosening the thumb screw and wing nut
found on the axle of the fill valve arm and adjusting the angle of the arm.
NOTE: If the thumb screw and wing nut are not loosened prior to adjustment, the axle
point on the arm may be stripped (Ex. 1).
• Final adjustments of the fill valve should be made while the pump is operating and the
water in the pond is at the desired level.
• Final adjustments can be made by simply bending the fill arm until the fill valve shuts the
water off at the desired level (Ex. 2).
General Maintenance
• The water fill valve requires no additional maintenance once it is set to the desired water level.
• Regular pond maintenance, such as removing debris from the skimmer basket or net will help the water fill valve to operate
accurately.
• Winter preparation – The water fill valve will not operate during extended freezing temperatures. Simply detach the
brass garden hose adaptor from water spigot. No additional steps need to be taken to clear water from the 1/2" poly-pipe.
#29272 • REV 10/18
2
For more information about our company or products, please visit our website at
aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426
©2018 Aquascape, Inc. • All Worldwide Rights Reserved
☎
STEP 9
TRENCH IRRIGATION LINE
• Trench 1/2" poly-pipe
irrigation line to water spigot
and connect using a brass
garden hose adaptor. The
irrigation line can be buried a
few inches below the surface
of the soil.
US (866) 877-6637 |
CAN (866) 766-3426 | aquascapeinc.com
☎
Ex. 1
Ex. 2
Publicité
