Parts And Components; Before Use; Product Assembly - cecotec Fast&Furious 4020 Force Manuel D'instructions

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Steam exit
2. On/off touch button
3. ECO mode touch button
4. Steam touch button
5. Handle
6. Swiveling cord
7. Steam push button/push button lock
8. Removable water tank
9. Removable brush for clothes

2. BEFORE USE

Take the product out of the box.
Make sure all the accessories are included and check for any visible damage. If any is observed,
contact the Technical Support Service of Cecotec.
Remove any sticker or protective element from the steamer head.
Unwind and straighten the cord.
Warning: When operating the garment steamer for the first time, allow it to steam for a few
minutes to remove any impurities and odours that might have been left from the manufacturing
process.

3. PRODUCT ASSEMBLY

Remove the water tank, open the water filling opening lid and pour water up to the MAX mark.
Replace the water tank. If tap water contains too much scale, it is recommended to use 50 % of
tap water with 50 % of natural water.
Introduce the clothes brush into the steam head and press until a click sounds, indicating that
it is properly fixed. It can be attached either way.
Connect the appliance to a power outlet and press for 2 seconds the On/Off touch button in
order to switch it on. The indicator light will flash for a few seconds, once it turns steady, the
product is ready to be used.
Note: Once the water tank is full and the appliance is connected to the power supply, allow it
to preheat for a few seconds.
Warning: Do not exceed the MAX. mark when filling the water tank.
FAST&FURIOUS 4020 FORCE 25