Technical Specifications; Disposal Of Old Electrical Appliances - cecotec 3D ForceAnodized 850 i-Pump Manuel D'instructions

ENGLISH
6. TROUBLESHOOTING
Problem
Not enough or too much
heat.
No steam or leakage.
Steam burst or vertical
steam do not work properly.
Water leaks from the
soleplate.
Little steam.
Spray does not work
properly.

7. TECHNICAL SPECIFICATIONS

Model: 3D ForceAnodized 850 i-Pump
Reference No: 05103
3100 W, 220-240 V, 50/60 Hz
Made in China | Designed in Spain

8. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), specifies that old household electrical appliances must not be disposed of with
the normal unsorted municipal waste. Old appliances must be collected separately, in
16 3D FORCEANODIZED 850 I-PUMP
Possible cause
The temperature knob is
not set correctly or it is
unplugged.
The temperature knob has
been set to MIN.
The steam-burst function
has been used too often
within a very short period.
The iron is not hot enough.
The iron is not hot enough.
Water is over the max mark.
Steam holes are blocked.
Too little water in the water
tank.
Not enough pressure or air
inside.
Solution
Set the temperature knob
to the correct position.
Continue ironing in
horizontal position and
wait a few minutes before
using the vertical steam-
burst function again.
Wait until the red light
indicator turns on.
Empty the left-over water.
Clean the hole with distilled
water.
Add water to the water
tank.
Press the spray nozzle
manually and press the
spray button several times
in a row.