Figure 11 - Electrolux TINSEB484MRR0 Instructions D'installation

(c) VErtIcal EXHaust:
outsIdE VEntIlatIon
1. Remove and save 2 screws from back edge and 3 screws from
the top center of the Fan Cover Bracket. Remove Fan Cover
Bracket by sliding it in the opposite direction of the arrow on
the Fan Cover Bracket as shown in Figure 11.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See
Figure 12. Caution: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 90˚ so that the fan blade openings
are facing the top of the oven. See Figure 13 (A). Replace
Hood Fan Unit into the oven. Be careful not to pinch the lead
wire between the inner bracket and the Hood Fan Unit. Put the
lead wire into Wire Box. See Figure 13 (B).
4. Replace the Fan Cover Bracket by sliding it into the slits in the
same direction as the arrow on the Fan Cover Bracket. Make
sure the fan blades are visible through the top openings in the
oven before proceeding.
5. Attach the Fan Cover Bracket to unit with the 2 screws from
back edge and 3 screws from the top center of the Fan
Cover Bracket, which were removed in Step 1 above. See
Figure 14. The Hood Fan Unit is now rotated for vertical
exhaust operation.
6. Attach the Exhaust Damper Assembly to the fan cover on the
top of the outercase cabinet by sliding it into the slits in the
same direction as the arrow. Use 1 Tapping Screw 4 x 12 mm
from the INSTALLATION HARDWARE and tighten into place.
See Figure 15.
Installation Instructions

Figure 11

Figure 12
(A) Rotate 90˚
5
(B)
Figure 13
Figure 14
Exhaust Damper Assembly
Figure 15
E