Danby DBSH01113WD13 Manuel Du Propriétaire page 12

OPERATING INSTRUCTIONS
OSCILLATION
Press the oscillation button to
begin the oscillation feature. The
heater will oscillate back and forth
while this feature is in operation.
Press the oscillation button again
to stop the oscillation feature.
CLEANING
1. Ensure the power is turned OFF
and the heater is unplugged.
2. Allow the heater to completely
cool before attempting any
cleaning.
3. The outer shell may be cleaned
with a soft, damp cloth. A
mild detergent can be used if
necessary.
4. After cleaning, dry the heater
with a soft, dry cloth.
5. Wait until the heater is
completely dry before using.
WARNING: Do not immerse the
heater in water or allow water to
enter the heater.
WARNING: Do not use alcohol,
gasoline, abrasive powders,
furniture polish or rough brushes
to clean the heater. This may cause
damage or deterioration to the
surface of the heater.
TROUBLESHOOTING
If the heater will not operate,
check the following:
1. Check that the power cord
is plugged into a 120 V AC
electrical outlet. Do not use
extension cords.
2. Check that the power
indicator light on the control
panel is illuminated to show
that the heater is getting
power from the outlet.
3. Check if the battery in the
remote control needs to be
replaced.
4. Unplug the heater, wait
15 minutes for the internal
components to reset and then
plug it back in.
5. Ensure that the heater is
placed on a fl at, fi rm surface
and that the tip over switch is
engaged.
STORAGE
Store the heater in a cool, dry
location when not in use. To
prevent dust and dirt build-up,
use the original packaging to
repack the heater.
11