Operation; Connect The Water Supply To The Machine; Use The Spray Gun; Change The Spray Tip - GreenWorks ELITE EPW2000 Manuel De L'utilisateur

2. Install and tighten the other end of the high pressure hose
onto the water outlet (23) coupler.
4

OPERATION

WARNING
Make sure that all the connections are tight and have no
leakage before operation.
4.1 CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
22
1. Uncoil the garden hose (24).
2. Let the water flow through the garden hose (24) for 30
seconds.
English
24
9
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (24) to the
water inlet (22) connector.
CAUTION
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
4.2

USE THE SPRAY GUN

WARNING
For safe control, keep your hands on the gun at all times.
• Pull and hold the spray gun trigger (25) to start the
machine.
• Release the spray gun trigger (25) to stop water flow
through the spray tip (11).
4.2.1 UNLOCK THE SPRAY GUN TRIGGER
• Push the trigger safety lock-out (26) down until it clicks
into the slot.
4.2.2 LOCK THE SPRAY GUN TRIGGER
• Push the trigger safety lock-out (26) up and into it's
original position.
4.3

CHANGE THE SPRAY TIP

11
27
25 26
EN