Commissioning; Assemble The Telescopic Bracket; Assemble Telescopic Bracket - Haaga 355 Manuel D'utilisation Original

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Commissioning

6.
Commissioning

6.1 Assemble the telescopic bracket

1
Fig. 7: Assembly of the telescopic bracket
On delivery, the 2 telescopic pipes (1) and the
sliding brackets (2) or individual parts.
1. Press the locking springs (3) inwards on both
sides of the telescopic pipes.
2. Push the telescopic pipe (1) into the sliding
bracket (2).
3. Push the telescopic tube into the sliding
brackets until the locking springs on both
sides lock in.
»
Make sure that the locking springs lock in at
the same height on both sides.
SPEEDY SWEEP® 1-877-977-3339
JanitorialEquipmentSupply.com
10
2
3

6.2 Assemble telescopic bracket

CAUTION
Risk of injury through tipping over of the
telescopic bracket!
Tipping over of the telescopic bracket may
lead to slight injuries, such as jamming of
the finger or haematomas in users or other
persons.
• When carrying the device, hold it so that the
telescopic bracket cannot tip over.
3
1
Fig. 8: Assembly of the telescopic bracket
1. Turn the handles (1) into the vertical position.
2. Press the locking springs (2) inwards on both
sides of the telescopic sliding bracket.
3. Push the telescopic sliding bracket (3) into
both handles simultaneously.
4. Push the telescopic sliding bracket into the
handles until the locking springs lock in.
2

Publicité

Table des Matières
loading

Table des Matières