Olympia A2250 Mode D'emploi page 25

Adhesive and other residues on the rollers can impair the lamination result.
Remove these at regular intervals and whenever the lamination result is not as
good as expected.
1. Switch the On/Off switch to ON.
2. Press the Operating Mode button, several times if necessary, until one of
the hot lamination control lamps lights up. The drive motor for the rollers
starts up.
Pay attention to the warm-up time stipulated in "Technical Data".
3. Fold a sheet of paper and feed it into the laminator with the folded edge
the paper when ejected.
4. Repeat the process with a new sheet of paper until the paper comes out
clean.
Clean the laminator at regular intervals.
1. Before cleaning, disconnect the plug from the power socket.
2. Use a damp, lint-free cloth to clean the laminator surface. Do not use any
solvents or cleaning agents.
L A2250 / A3250
AMINATOR
25