General Instructions - JANE CONCORD MATRIX PLATFORM Mode D'emploi

GENERAL INSTRUCTIONS

In order to protect the baby correctly and guarantee his comfort and safety
in the car, it is necessary to follow the instructions below:
The Matrix Platform can be installed on the
front seat, if there is no airbag, or on the
back seat. It is advisable to install it on the
back seat. If you install it on the front seat
of the car, the seat must not have an airbag,
or it must be disconnected.
The Matrix platform can only be installed
using ISOfix fasteners. It has a leg as an
anti-swivel mechanism, adjust it correctly
so that it is supported by the floor of the
vehicle.
Not all systems are the same, so we advise
you to check this in the vehicle in which the
platform is going to be installed. To install
the platform, read the instruction manual
for your car, as this will indicate which seats
are compatible with the platform. The Ma-
trix platform is compatible with the ISOfix
categories: Classes C, D, E, F and G.
It is very important NOT to use second-hand
products, since JANÉ-CONCORD can only
guarantee the complete safety of articles
used by the original buyer.
JANÉ-CONCORD recommends that the Ma-
trix platform should be replaced by a new
one when it has been subjected to severe
strain in the event of an accident.
Regularly check that the ISOfix fasteners
and the anti-swivel leg are correctly con-
nected and/or adjusted.
This platform has been designed for use in
the car, therefore, it should not be used out
of the car.
19