Transporting The Machine; Electrical Connection - Tornado TV2 Manuel D'utilisation Et D'entretien

All manuals and user guides at all-guides.com
 Operators should be able to recognise unusual
operation of the machine and report any
problems.
 Only use the machine on firm level surfaces.
 Wear suitable footwear to avoid slipping.
 Wear suitable clothing to keep dry and warm.
 Where possible implement job rotation and
adequate rest periods to avoid continuous use
of the same muscles.
 Do not leave machine running unattended
 Do not smoke when using the machine.
 Do not put any objects into openings. Do not
use with any opening blocked: keep free of
dust, debris, hair, or anything that may reduce
air flow.
CAUTION - This machine is for indoor
dry use only and should not be used or
stored outdoors or in wet conditions.
CAUTION - If it is suspected that there is
hazardous dust or flammable materials
stop cleaning the area immediately and
consult your superior.
WARNING Only use accessories and
spare parts provided with the machine or
those approved by the manufacturer.
The use of other accessories may impair
the safety of the machine.
 Ensure the machine is switched off before
adding or changing accessories.

1.3 Transporting the machine

CAUTION – Incorrect lifting techniques
may result in personal injury, where
applicable do not lift large and heavy
machines without assistance. We advise that the
manual handling regulations are followed.
Please refer to the technical table for details on
weight of machine.
When transporting the machine ensure that all
components, tanks and removable parts are
securely fastened, and that the supply cord and
plug are not trailing. Detach hose and wand from
machine where applicable.
Take extreme care when moving the machine up
or down steps or stairs.
2 Preparing for use

2.1 Electrical connection

Before connecting the machine to the power
supply, check that your
corresponds with that marked on the rating label.
The power supply cord plus any extension leads
should not exceed 100 ft. (30m) in total,
otherwise you may experience problems starting
up the machine. The cross-section of any
extension cable wiring must be at least AWG 13
(2,5 mm
Should an extension cord be used, ensure cord
rating is adequate for the equipment. Do not use
extension cord in coiled condition as this could
result in overheating of the cord.
IMPORTANT - If the supply cord is damaged, it
must only be replaced by a special cord available
from the manufacturer or an authorised service
agent.
2.2 Symbols & Markings
2.3 How to assemble the vacuum
and unplug from the electricity supply.
 Insert the hose into the socket on the front of
the vacuum cleaner (Fig 1).
 Twist in a clockwise direction until locked into
position.
2.4 Fitting the handle, wand and floor tool

Fit the handle to the wand connection (Fig 2).
supply voltage
5
²).
WARNING
WARNING - Before
assembly or changing
accessories/tools switch off machine
Fig 1
undertaking
of