Horizon Global 76920 Instructions D'installation page 4

Always wear SAFETY GLASSES
when installing hitch
Fasteners
typical
both sides
Existing
Fasteners
Bumper
Beam
Use items 1
and 2 if
accessible
Figure 2
1. Fascia and bumper beam removal – Use T20 star driver to remove (4) screws from bottom fascia and (5 on XC90, 7 on XC60) screws from wheel well each side.
Open the trunk (XC60 remove the bump stops) and gently remove the fascia. Unplug (2 on XC90, 1 on XC60) wirings from the fascia and carefully set the fascia
aside. Use 15mm socket to remove (3) flange nuts from bumper beam each side and then remove bumper beam. Set the bumper beam and fasteners aside
carefully. NOTE: Some models might have (4) flange nuts on bumper beam each side.
2. Hitch installation - Raise the hitch into position and align bracket holes to the studs on end panel. Raise bumper beam to sandwich the hitch. Reuse flange nuts
from bumper see Figure 1. If a fourth hole in the bumper is open use items j and k see Figure 2.
3. Tighten all M10 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M).
4. Fascia trimming and reinstallation – Mark the center line on the fascia and trim the area on fascia as shown in Figure 3. *Do not trim on sensor bracket area.
Reinstall all fasteners, wiring, and fascia removed in step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and
requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2022 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
PART NUMBER: 76920
End Panel
Figure 1
Proper torque is needed to keep the hitch secure to the vehicle when towing
Bumper
Sheet 4 of 12
Fastener Kit: 76920F
① Qty. (2) Bolt M10
1.5 x 45 CL10.9
② Qty. (2) Conical washer 7/16 ''
l
Qty. (1) Warning Card
m
Qty. (2) Warning Label
n Qty. (2) Bolt
M12x1.75x100 mm, CL10.9
⑥ Qty. (2) Flat Washer 7/16''
Part#: 0116007
⑦ Qty. (2) Prevailing Torque Nut
M12x1.75, CL10
Figure 3
.
76920N 4-14-22 Rev. A