sunjoe 24V-PWSCRB-LTW Manuel D'utilisation page 8

2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 3 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
Assembling Pole Attachment
1. The power scrubber should arrive pre-assembled with the
large flat brush, scrubber head, and handle attached.
To add extra length by using the pole attachment,
first unscrew the handle locking collar until the handle and
head are able to detach (Fig. 3).
Fig. 3
Scrubber head
Battery
indicators
2. Align the arrows on the pole attachment with the arrows
on the scrubber head and slide together. Use the pole
locking collar to screw in place (Fig. 4).
Fig. 4
3. Align the arrows on the pole attachment with the arrows
on the scrubber handle and slide together. Use the handle
locking collar to screw in place (Fig. 5).
Fig. 5
attachment
8
Handle locking collar
Pole locking collar
Scrubber head
Handle locking collar
Pole
Handle
Pole
attachment
Handle