sunjoe 24V-PWSCRB-LTW Manuel D'utilisation page 10

Adjusting Scrubber Head
1. Push and hold down the head adjustment button to adjust
the angle of the scrubber head if desired. The scrubber
head can tilt up to 45º (Fig. 11).
Head adjustment button
Fig. 11
Starting + Stopping
1. Insert the battery into the battery compartment on the
handle (Fig. 12).
Fig. 12
Battery
compartment
2. Turn the unit on by using one of the brush's two speeds.
From the middle OFF setting, slide the switch forward for
the slow setting. From the OFF position, slide the switch
back for the fast setting (Fig. 13).
Fig. 13
Middle (OFF)
Slow setting
3. When shutting down the unit, keep the brush in contact
with the surface to avoid splatter. Slide the switch to the
center OFF position (Fig. 13), and remove the battery.
.
Scrubber head
Battery
Fast setting
Maintenance
m
CAUTION!
Before working on the cordless power
scrubber, switch off the unit and remove the battery from the
compartment.
Cleaning the Scrubber
It is recommended to clean and dry the power scrubber and
attachments after each use to maintain optimum functionality
for long-term use.
• Clean the scrubber and attachments with a mild detergent
and a soft sponge or cloth.
• Make sure the scrubber is completely dry before stored in
a safe, dry location. Keep the battery and motor dry at all
times.
Storage
• Store the power scrubber indoors in a safe, dry location.
Battery Caution + Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
m
CAUTION!
Even discharged battery packs contain
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a fire or explosion.
m
WARNING!
To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead or completely discharged. When burned, toxic fumes and
materials are emitted into the surrounding atmosphere.
1. Batteries vary according to device. Consult your manual
for specific information.
2. Install only new batteries of the same type in your product
(where applicable).
3. Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
4. Do not mix old and new batteries.
5. Do not mix Alkaline, Standard (Carbon-Zinc) or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride,
or Lithium-Ion) batteries.
6. Do not dispose of batteries in fire.
7. Batteries should be recycled or disposed of as per state
and local guidelines.
10