Table des Matières
Publicité
Assembly (You will need a screwdriver.)
1. Carefully remove all components
from the package and check to
ensure nothing is damaged. If
equipment is damaged,
immediately notify the retailer from
where the equipment was
purchased.
2. The sand filter should be placed on
solid, level ground, preferably a concrete slab.
Position the sand filter so the Ports and Control Valve
are accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter
to be vertically fixed on ground or a certain pedestal
made of wood or concrete before use to prevent the
sand filter from accidentally falling. Fully assembled
sand filter will exceed 18 kg. The mounting holes
should be 8 mm in diameter and spaced 86 mm apart.
Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear
Polysphere.
NOTE: Use only special pool-grade filter sand, free of
all limestone or clay: #20 Silica sand 0.45-0.85 mm,
approximately one 36 kg bag should suffice. If you do
not use the recommended size filter sand, filtering
performance will be reduced and the sand filter may
damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding
sand, pour some water into the Bottom Tank to
submerse the Skimmer on the Collector Hub.
NOTE: Sand/Flowclear
included.
NOTE: Use 28 g (0.06 lbs) Flowclear
replace 1 kg (2.20 lbs) sand.
303021216269_58497GS_14x21cm_1500gal 德规砂滤器说明书-英
Ф8 mm
™
Polysphere not
™
Polysphere to
8
86 mm
™
Publicité
Table des Matières
