Oblique Angle - Hitachi C 10FCB Mode D'emploi

4. Oblique angle

Fig. 10
8 mm
Bolt
Fig. 11
5. Securing the workpiece
WARNING:
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
6. Installing the holders (Optional accessory)
6 mm
Wing Bolt
Holder
Steel
Squar
Fig. 12
Before the power tool is shipped from the factory, it is adjusted for
0° and left 45° bevel cutting angles.
The positioning and bevel cutting angle can be adjusted by
changing the height of the 8 mm bolt.
(Maximum bevel cutting angle is 45°).
8 mm
Bolt
The holders help keep longer workpieces stable and in place during
the cutting operation.
(1) As indicated in Fig. 12, use a steel square for aligning the upper
edge of the holders with the base surface.
(2) After aligning, secure the holders with the 6 mm wing bolts.
Base Surface
English
13