Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
OPTIONAL ACCESSORIES
q Extension Holder and Stopper (Code No. 320498)
w Saw blade 10" (255 mm) TCT Saw blade for fine surface cut (Total teeth: 60) (Code No. 976472)
e Saw blade 10" (255 mm) TCT Saw blade for aluminum cut (Total teeth: 100) (Code No. 319658)
WARNING:
Using attachments or accessories not recommended in this manual can be dangerous
and cause personal injury or mechanical damage to the saw.
APPLICATIONS
Wood, plywood, color board, soft fabric board, hard board similar materials and aluminum sash.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
5-5/16" (160 mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1" (25 mm) plus the thickness of the work bench.
For example, use 2" (50 mm) or larger bolts for a 1" (25 mm) thick work bench.
2. Releasing the locking pin
Locking
Pin
Fig. 5
3. Installing the dust bag, holder and vises. (The holder is optinal accessory.)
Attach the dust bag, holder, and vises as indicated in Fig. 1.
10
...sold separately
11/32"
(9 mm)
3 Holes
∨
13-3/8" (340 mm)
When the power tool is prepared for shipping, its main parts are
secured by a locking pin.
Move the handle (see Fig. 1) slightly so that the locking pin can be
disengaged.
During transport, lock the locking pin into the gear case.
NOTE:
Base
Work Bench
Fig. 4
Lowering the handle (see Fig. 1) slightly will enable you
to disengage the locking pin more easily safely.
The lock pisition of the locking pin is for carrying and
storage only.
5/16" (8 mm) Bolt
∨
5/16" (8 mm) Nut
Publicité
Table des Matières
