Publicité
Les langues disponibles
Les langues disponibles
STEP 6:
Install fixture up into the recessed housing
firmly until trim ring is flush with the
ceiling. Rotate fixture clockwise slightly to
tighten fit with ceiling and set in recessed
housing. For best results, ensure""Flip
Clips·· are not aligned with metal trim
clips inside of recessed housing during
Figure 3 and 4.
installation. See
STEP7:
If the trim ring is not flush with the ceiling,
remove fixture by turning counterclockwise
while pulling downward. Remove the fixture
completely from the recessed can by either turning
the fixture Edison base counterclockwise, twisting GU24
socket counterclockwise, or unplugging LED Adapter.
CAUTION:
Changes or modifications not expressly approved could void your authority to use this equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- R e o r i e n t or relocate the receiving antenna.
- I n c r e a s e the separation between the equipment and receiver.
- C o n n e c t the equipment into an outlet on a circuit different from that to which the receiver is connected.
- C o n s u l t the dealer or an experienced radio/TV technician for help.
In accordance with California Proposition 65, Cree provides the following statement due to the customary electronics
components used in this product. WARNING: This product contains a chemical known to the state of California to
cause cancer. WARNING: This product contains a chemical known to the state of California to cause birth defects
or other reproductive harm.
© 2018 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
is a registered trademark, and the Cree logo is a trademark of Cree, Inc.
Cree
®
2 of 2
STEP 8:
Locate the recessed can socket and remove
socket b racketry and/or socket plate to allow
the socket to hang freely. See
STEP 9:
Screw/insert fixture into the recessed can
Edison socket, GU24 socket, or LED Adapter
and reinstall fixture into the recessed can.
REMOVAL O F FIXTURE
NOTE:
disconnected before attempting to
remove fixture module from fixture.
STEP 1:
To remove fixture, grip firmly on
the trim ring and rotate 1/4 turn
counterclockwise to unlock clips
from recessed can.
STEP 2:
Continue to turn counterclockwise
while pulling d o w n ward on the
fixture. This will disengage the clips
allowing the fixture to pull free.
STEP 3:
Detach fixture from recessed housing
socket.
Figures 5.
Make sure power to fixture is
CREE
LPN000246
Publicité
