Cree CR4-T Serie Mode D'emploi

CREE
IMPORTANT SAFEGUARDS
WARNING - Risk of fire or electric shock. Disconnect power at fuse or
circuit breaker before installing or servicing.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. WARNING - Risk of fire or electric shock. LED Retrofit Kit
installation requires knowledge of luminaires electrical
systems. If not qualified, do not attempt installation. Contact a
qualified electrician.
2. WARNING - To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects.
3. WARNING - Risk of fire or electric shock. Install this kit only
i n the luminaires that have the construction features and
dimensions shown i n the photographs and/or drawings where
the input rating of the retrofit kit does not exceed the input rating
of the luminaire.
4. SUITABLE FOR TYPE IC LUMINAIRES.
It may be necessary to remove a socket mounting plate for
5.
adequate clearance.
6.
Each lampholder shall be installed only i n its intended manner
and orientation.
7. Suitable for Wet Locations.
8. Min. temperature rating of -25
9. Do not make or alter any open holes i n an enclosure of wiring or
electrical components during kit installation.
10. SUITABLE FOR INSTALLATION IN A RECESSED CAN WITH A
MAXIMUM OF EIGHT (8) No. 12 AWG THROUGH-BRANCH CIRCUIT
CONDUCTORS SUITABLE FOR 75
11.
WARNING-THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT
OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION
SHALL BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
MIN. LAMP COMPARTMENT DIMENSIONS
4 inch/101.6mm (DIA) x 5 inch/127mm (H).
12. This device is not intended for use with emergency exit fixtures or
emergency exit lights.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
•
TO INSTALL:
Flip Clip
STEP 1:
Carefully rotate the "Hip Clips·· clockwise
until the clips are fully-deployed. See
STEP 3:
Remove existing trim and bulb, revealing
the existing recessed socket.
1 of 2
. . . . TM
°
C.
°
C MIN.
STEP 2:
Make sure the
Figure 2. the source to the recessed can.
STEP 4:
Install "Field Applied Label'" into the
recessed can.
INSTALLATION INSTRUCTIONS-ENGLISH
Package Contents:
Part
A
B
C
•
D
Minimum distance
between edge of
fixture and top of
housing or other
obstruction.
RECESSED HOUSING COMPATIBILITY
• Designed to install in standard 4in recessed downlight
housings.
• Compatible with most dimmers when used with multiple
fixtures. Consult lighting.cree.com for a
compatibility chart.
• Compatibility of housings may be determined by
measurement of the housing as detailed in the drawing
above
POWER IS TURNED OFF
at
CR4-T Series
4" Recessed LED Downlight
Description Quantity
4" Retrofit downliqht
Edison Socket Adapter
GU24 Socket Adaoter
Field aoolied label
5.5 inch 5 inch
(140mm) (127mm)
4inch
(101.6mm)
(Figure 1).
STEP 5:
FOR EDISON BASE SOCKET INSTALLATION:
Connect Edison socket adapter [part Bl to the
existing LED adapter attached to the
downlight. Then, screw the Edison base
socket into the recessed can Edison socket by
See Figure 3.
turning clockwise.
FOR GU24 SOCKET INSTALLATION:
GU24 socket adapter [part CJ to the existing
LED adapter attached to the down light. Then,
insert pins on GU24 base socket into the
recessed can GU24 socket by turning
See Figure 3.
clockwise until locked.
FOR LED DIRECT CONNECT INSTALLATION:
Connect down light LED adapter attached to
the downlight to the LED adapter attached to
the recessed can.
1
1
1
1
Connect
LPN000247