Subaru H001SSG502 Instructions D'installation page 7

WINDSHIELD MOUNT ANTENNA INSTALLATION -
7
EYESIGHT EQUIPPED VEHICLES, continued
HARNESS ROUTING
1. Plug the 5-pin antenna harness into the previously installed
antenna pod. (FIGURE T)
2. Route the antenna harness straight up into the headliner,
then across the headliner and down the A-pillar tucking the
cable below the driver's side dashboard through the opening
closest to the windshield and allow the harness to hang
loose behind the vehicle's dashboard mounted fusebox. The
antenna harness will be plugged into the remote start control
module later. (FIGURE U)
3. Secure the antenna harness to the existing vehicle wiring in
the A-pillar in six (6) places using the supplied 8" tie wraps.
Wrap the tie wraps with the supplied small foam pads to
prevent rattling. (FIGURE V)
4. Using one of the supplied 8" tie wraps, secure the antenna
harness to the vehicle wiring behind the fusebox.
5. Re-install the airbag tether clip to the A pillar panel and
rotate the panel into place.
6. Re-install the A pillar panel and driver's side dashboard tweeter
cover.
PART NUMBER ISSUE
H001SSG502
DATE
6 Feb 2017
00
FIGURE U
FIGURE V
SUBARU OF AMERICA
FIGURE T
7 OF 14