Controls - Uberhaus GJC10CI-A3RNA5A Guide De L'utilisateur

Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
ON/OFF Button
Press this button to turn on or turn off
the air conditioner.
Display
1. Under ON status without timer setting,
the operation modes are Auto, Cool,
Energy Saving, Fan or Dry mode, and
the set temperature will be displayed.
2. Time will be displayed under timer set-
ting or timer preview status.
Temp Increase
Press this button to set temperature under
Cool, Energy saving or Dry mode.
Timer Increase
Each touch of the Increase
button on the unit will set the delay time
when using the Timer button on the unit
The Set light will flash while setting.
Fan Speed Buttons
Press this button to set
high or auto fan speed.
Note: Under dry mode, the fan speed cannot
be adjusted.

Controls

Air Conditioner Controls
/Decrease Buttons
/Decrease Buttons
/Decrease
low, medium,
Mode Button
Press this button to set
Fan , Dry or Auto mode.
The matching indicator light will turn on. Please note that
under Auto mode, no indicator light will be on.
Timer Button
The setting range is 0.5~24hr.
Timer ON can be set with air conditioning OFF. When timer
reaches ON time, the system will run under previous set-
ting mode.
Timer OFF can be set with air conditioning ON. When timer
reaches OFF time, the unit will be turn off. The timer can be
set in 0.5 hour increments below 10 hours and in 1 hour
increments for 10 hours or above.
8
Filter check button
After 250 hours of operation, the air filter must be cleaned;
the "clean filter" indicator light will turn on.
Note: Once filter has been cleaned, press Filter check button
to clear the warning. The "clean filter" indicator light
will turn off.
Sleep Button
Press this button to go into the SLEEP mode.
Press it again to cancel this function. This function is
available in COOL,Energy Saving or DRY mode to
maintain the most comfortable temperature for you.
15
Cool, Energy Saving,