Pattfield PE-1400 KS Traduction De La Notice Originale page 89

CALIBRATE ANGLES
1 Use an 90° try square to calibrate the
tool. The alignment can be set by the
straight guide locking screws
the bevel lock knob 19.
Caution! Make sure the tool is
switched off and unplugged.
MITRE CUTS
1 Open the rotary table locking knob 16.
Use the rotary table handle
the desired angle for mitre cuts.
There are defaults for 0°, 15°, 22,5°,
30° and 45° in both directions.
BEVEL CUTS
1
Open the bevel lock knob 19.
SAW BLADE REPLACEMENT
1 Press the spindle lock lever
loosen the saw blade clamp
with the hex key.
Caution! Make sure the tool is
switched off and unplugged and
wear protective gloves.
3 Place a new saw blade in the tool.
Make sure the rotation arrow points to
the lower front of the saw.
Caution! Observe that the rotation
direction of the saw blade corre-
sponds with the indication on the tool.
PKS210_Kappsäge_Content_V1.0_13-10-11.indd 87
All manuals and user guides at all-guides.com
17 and
15 to set
14 and
washer 3
RELEASE KNOB
2 Pull out the release
the saw arm 13.
To lock the saw arm 13
tion, push it down and press in the re-
lease knob 20.
2 Set the desired angle and tighten the
rotary table locking
Mitre cuts can be combined with bevel
cuts.
2
Set the desired angle and tighten the
bevel lock knob 19
Bevel cuts can be combined with mitre
cuts.
2 Remove the saw blade
Do not remove the inner blade washer.
4 Press the spindle lock lever
and tighten the saw blade clamp wash-
er 3 with the hex key.
knob 20 to unlock
in lower posi-
knob 16 securely.
securely.
12 from the tool.
14 again
EN 87
14.10.13 16:24