Télécharger Imprimer la page

WeatherTech BumperTopper Instructions D'installation

Publicité

Liens rapides

BumperTopper
Alcohol Pads
BumperTopper
Installation Instructions
1
Wash the rear bumper of your vehicle
and completely dry with a clean cloth. It is
important that the bumper remains completely
dry and free of any dirt and debris throughout
the installation process.
4
Once you outline it, remove the BumperTopper
and use the included alcohol pads to deep
clean the contact area, then let dry completely.
7
Remove the adhesive liner. Grasp the
exposed portion of the adhesive liner and
pull gently with one hand while applying light,
even pressure to the BumperTopper with
your opposite hand. Repeat this step until all
adhesive liner has been removed.
LET'S TALK
800-441-6287
For warranty information, please visit www.WeatherTech.com/warranty
Masking Tape*
*Not included
2
Center the BumperTopper on the bumper
using character lines of your bumper, aligning
with the Center Indication Mark to help with
proper placement.
5
Prepare for installation by peeling back the
adhesive liner from each section on the
underside of the BumperTopper. Fold the
adhesive liners back far enough to create
pull tabs.
8
Using the palm of your hand, apply additional
pressure from the center out, pressing down
firmly along all the adhesive lined edges to
ensure proper adhesion.
NOTE: Please make sure vehicle surface and
BumperTopper are at or above 60° F (16° C)
for proper tape adhesion.
3
With the BumperTopper held in place on
your bumper, outline the edges of it on your
bumper with masking tape.
6
Carefully place the BumperTopper back into
position, centered and within the outlined
masking tape on your bumper. Remove the
masking tape.
9
Congratulations on installing your
WeatherTech BumperTopper! Your
BumperTopper will be fully bonded within 24
hours. Do not wash your vehicle for 72 hours
after installation.
67BT001 © 2022 MacNeil IP LLC

Publicité

loading

Sommaire des Matières pour WeatherTech BumperTopper

  • Page 1 Masking Tape* *Not included NOTE: Please make sure vehicle surface and BumperTopper BumperTopper are at or above 60° F (16° C) for proper tape adhesion. Installation Instructions Wash the rear bumper of your vehicle Center the BumperTopper on the bumper With the BumperTopper held in place on and completely dry with a clean cloth.
  • Page 2 60 °F (16 °C) o más para que la cinta se adhiera correctamente. BumperTopper REMARQUE : Pour assurer une bonne adhésion du ruban, veuillez vous assurer que la surface du véhicule et le BumperTopper sont à une température égale ou Instrucciones de instalación Instructions d’installation supérieure à...