Yokis E2BP Mode D'emploi page 9

DIRECT MODE CENTRALISATION
A command can be centralised by repeating the same procedure on up to four receivers. In case that more than 4 receivers
should be driven, use the Radio Bus.
RADIO BUS MODE
An unlimited number of receivers may be connected together to form a radio bus. This makes it possible to:
• send controls to groups of receivers on the radio bus (see "Radio Memo")
• send a control from a transmitter to a receiver which is out of direct range
• centralise operation of all lights or all window shutters.
All receivers (MTR2000ERP - MTV500ERP - MVR500ER) are compatible with the radio bus.
The window shutter controls may also be sent via lighting modules and vice versa.
See the "Radio Memo" or go to www.yokis.com for more information on the radio bus.
Note: For correct operation of the YOKIS radio bus, the receiver modules must all be connected to the same power phase (L)
and there must be no phase (L) and neutral (N) reversals on any receiver module. Follow the installation diagrams carefully.
HOW TO CREATE A RADIO BUS BETWEEN RECEIVERS
Press "Connect" on receiver 1. Its LED will start flashing
While the LED is flashing, press "Connect" on receiver 2
To confirm the connection, the LED of receiver 2 will flash once and the LED of receiver 1 will stop flashing. The relays of the
two receivers will switch once when the connection has been established.
Possible with all
Yokis receiver
Led
R1
Connect
HOW TO INCREASE THE RANGE USING AN INTERMEDIATE RECEIVER
1. Define a radio bus between receivers as described above.
2. Connect the transmitter to the receiver to be controlled by pressing the chosen pushbutton on the transmitter (E) 5 times.
Press the pushbutton in the "Connect" hole of the receiver (R) while the transmitter LED is flashing.
3. At this point, create an access point on the receiver nearest to the transmitter by pressing the transmitter (E) pushbutton 7
times (the same one programmed in the previous step). The transmitter LED will start flashing rapidly. Then press the
pushbutton in the "Connect" hole of the first receiver (R) once (1 press). The transmitter and receiver LED will stop flashing.
RADIO BUS CENTRALISATION
The following five steps are needed for centralisation:
1. Create the radio bus between receivers
Follow the procedure described above.
DS1054-063
.
.
Led
R1 R1
Connect
P9
Unlimited number
of receivers on the
radio bus
Led
R1 R1
Connect
Led
R1
Connect