Direct Mode - Yokis E2BP Mode D'emploi

FLUSH-MOUNTED RADIO TRANSMITTERS
E2BPX 2-channel transmitter with external aerial
5454408
E2BPP 5454413 2-channel flush-mounted POWER
transmitter
E2BPPX 5454414 2-channel flush-mounted POWER
transmitter POWER with external aerial
E4BPP 4-channel flush-mounted POWER
5454427
transmitter
E4BPPX 4-channel flush-mounted POWER
5454428
transmitter with external aerial
Technical specifications:
- CR2032 Lithium battery (included)
- Battery life > 7 years
- Max. 4 receivers per transmitter channel
- Operating temperature: from -10 to + 50°C
- IP54 protection
- Max. relative humidity 80%
- Frequency: 2.4 GHz
- Transmission: two-way
WARNING: Explosion risk if the battery is replaced with a battery other than the referred one. Dispose of the used batteries as
per local standards. Do not ingest the battery. The battery can cause chemical burns and death if ingested. In this case, contact
a doctor immediately. Do not dispose of in fire.
WIRING THE E2BPP / E4BPP TRANSMITTER

DIRECT MODE

1
Press the pushbutton to be connected on the transmitter
(E) 5 times*.
The transmitter LED will start flashing for 30 seconds,
indicating that the system is waiting for connection.
* Each press must last less than 0.7 seconds.
2
Briefly press the pushbutton in the 'connect' hole of the
receiver (R) (on the front or the back of the receiver) with
the point of a pencil while the transmitter LED is flashing.
The transmitter LED will stop flashing.
Warning: the receiver must be powered.
DS1054-063
The E2BPP/E4BPP may be wired behind pushbuttons (or
switches) of any model. Wiring both channels is not
indispensable: a single pushbutton can be used connected to a
single channel. Insulate unused wires.
Switches can be used instead of pushbuttons to drive
MTR2000ERP receivers.
In this case, switch 5 times rapidly (not 10!) instead of using the
5 press sequence. Repeat the connection procedure by
pressing 5 times to use a pushbutton again instead of the
switch.
WARNING:
Do not connect this product to the 230V mains.
RADIO RANGE:
Standard range:
• In the same room < 100m²
• 50m in open range
(Range may be reduced by presence of metallic
elements, crossing of walls or partitions)
Power range:
• Inside 100m² apartments with perpendicular
crossing of main wall or ceiling
• 250m in open range
(Range may be reduced by presence of metallic
elements, crossing of walls or partitions)
RADIO TRANSMISSION:
The transmitter LED lights up only if radio
transmission
Adding an intermediate receiver will allow to solve a
problem of insufficient range (see § "How to increase
the range").
The LED will light up on transmitters only if radio
transmission was successful.
Simply repeat the same procedure
All YOKIS transmitters are compatible with YOKIS
receivers (Relays, dimmer, Shutter Modules, Actuator
module, Heating module).
P8
GB
was
White
Green
Brown
Violet
Grey
White
Green
Brown
to delete a connection.
successful.