ROBLIN OSMOSE VERRE Notice page 9

3 FITTING
Any permanent electrical installation must comply with the latest regulations concerning this type of
installation and a qualified electrician must carry out the work. Non-compliance could cause serious
accidents or injury and would deem the manufacturers guarantee null and void.
IMPORTANT - The wires in this mains lead are coloured in accordance with the following code :
- green/yellow : earth
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
- The wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol or coloured green or green and yellow.
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.
ATTENTION: Do not forget to use adequate plugs to the support brackets. Enquire after the manu-
facturers. Do an embedding if necessary. The manufacturer accepts no responsibility in case of a
faulty hanging due to the drilling and the setting up of plugs.
GB
1) Unpack the hood parcel.
• LAYING OUT BEFORE FITTING THE HOOD
2) Draw the horizontal axes (a;b) running parallel to the stove top onto the ceiling as illustrated Fig. 1.
3) Draw center over these axes as illustrated Fig. 2b
• FITTING THE CANOPY BRACKET
4) Mark the positions on the ceiling for :
mode and Ø 200 mm in the remote mode when ducting runs through the ceiling.
Drill the different holes with the appropriate masonry bit. When fixing the cooker hood to a plasterboard
ceiling ensure it is reinforced as illustrated in Fig. 3 and attach using four Ø10mm nuts and bolts; ensuring
the bolts as sleeved between the plasterboard and the joist supports to prevent the ceiling being damaged
when the bolts are tightened up.
If the ceiling is concrete, use eight Ø 10 mm steel rawl bolts. Plastic rawl plugs must not be used.
5) The height of the cooker hood can be adjusted in 50 mm stages Fig.5 . 650 mm when fitting above
an electric hotplate and 700 mm when fitting above a gas hotplate. Select the height required using the
measurements illustrated in and fix the metal diffuser to the frame of the chimney brackets using the
height 5 x 10T hexagonal headed screws. A drawing on the drill gauge defines the positioning for the
controls (cde) Fig. 2b.
Attention: 2 persons are necessary to secure this operation.
6) Check the vertical of the chimney.
- blue : neutral
- The cut-out for the ducting Ø 150 mm in the extraction
- The mains supply cords.Ø 40 mm
- The 4 fixing holes for Ø 10 mm nuts and bolts.
- brown : live
GB
7