Jenn-Air 740-0711 Instructions D'installation Et Guide D'utilisation Et D'entretien page 19

Prepare the Gas Supply
1. Open the hood completely. Do not light burners with the hood
closed.
2. Make sure control knobs are turned to OFF. The drip tray must be in
place and pushed all the way to the back.
A
Turn the Gas Supply On
1. For outdoor grills using a 20 lb LP gas fuel tank: 
Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not light. If
your grill does light, the flames will be low and will not heat
properly. Turn tank valve and all control knobs off and wait 30
seconds. After shutting off the tank, very slowly open tank valve and
wait 5 seconds before lighting.
2. For outdoor grills using gas supply source other than 20 lb LP gas
fuel tank: 
Open the manual shutoff valve in the gas supply line. The valve is
open when the handle is parallel to the gas pipe.
A
Lighting the Main Grill
IMPORTANT: If burner does not light immediately, turn the burner
knob to OFF and wait 5 minutes before relighting.
1. Do not lean over the grill.
2. Select the burner you want to light. Push in and turn the grill burner
control knob to IGNITE/HI, while continuing to hold 
it in.
3. You will hear the "snapping" sound of the spark. When burner is lit,
release the knob. Turn knob to desired setting.
4. Repeat for each of the other burners as needed.
A. Drip tray
B
A. Closed valve
B. Open valve
Manually Lighting the Main Grill
1. Do not lean over the grill.
2. Remove the manual lighting extension (see following illustration)
and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the lit match under the grill grate.
5. Push in and turn the burner knob to IGNITE/HI for the burner
closest to the lit match. The burner will light immediately. When
burner is lit, turn knob to desired setting.
6. Repeat steps 2 through 5 for each main burner.
7. Remove match and replace manual lighting extension on the right
side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF and
wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the "Assistance" section.
19