Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite HL Linear High Bay Generation 3
®
Installation & Operation
B: Cable Mounting Installation: HL3-CHKIT (mounting kit available separately)
Included with the mounting kit
A Metal cables - 2pcs
1. Run the cable kit wires through the four holes provided at each end of the fixture as shown in Figure B-1. Ensure that the
fastener passes through the hole completely Figure B-3.
2. Use the regulator to adjust the height of the fixture Figure B-4.
3. Ensure that the fixture is upright and the power conduit is not stressed.
4. Use the flexible metallic conduit to run the line, neutral and ground wires for powering the fixture. (Figure B-1)
flexible metallic conduit
C. Surface Mounting Installation: HL3-SMKIT (mounting kit available separately)
Included with the mounting kit
A
Mounting bracket - 2pcs
B
Hex Cap screws with washers - 4pcs
1. Align the surface mount brackets with the fixture back plate as show in the Figure C-1
2. Screw the hexagonal head screws into the rivet nut to fix the surface mount brackets on the fixture body.
(Figure C-1)
3. Locate the holes on the surface mount brackets and mark the corresponding hole positions on the mounting
4. Nail the anchors at each mark on the mounting surface. Drill the self-tapping screws at the marks. (Figure C-2)
surface.
5. Lift the fixture to the surface and ensure that each screw passes through the center hole of the mounting bracket.
(Figure C-3)
6. Slide the fixture to the position so that the fixture stays secured in its place. (Figure C-4)
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Fig. B-1
Fig. C-1
Fig. B-2
Mounting Surface
Anchors
Fig. C-2
Fig. B-3
Fig. C-3
HL3 Series
Fig. B-4
Fig. C-4
Page: 3
REV: 11/02/22
Publicité
