Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite HL Linear High Bay Generation 3
®
Standard Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit
breaker box before wiring fixture to the power supply.
All units must be individually connected to the
AC supply.
Color Temperature Switching Instructions
1. Locate the CCT switch on the lighting fixture. The tab on
the switch can be used to adjust CCT.
2. Based on the requirements the switch can be used to operate the fixture at 4000K or 5000K. (Default = 5000K)
NOTE: For the HL3-360 models, there are 2 CCT switches and both need to be adjusted to the required CCT
NOTE: For wattage select model the default wattage is the lowest setting.
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. Remove the new LED fixture from packaging and inspect for any damage. Handle new LED fixture with care.
2. Connect the LED high bay wiring to line wire, black to black, white to white and green to green. Use only UL listed wiring.
3. Clean all residues/fingerprints from the new LED high bay and lens. Double check all
hanging hardware before moving onto the next installation.
A: Chain Mounting Installation
1. Ensure that both 40° knotted chains have a small hook on both ends.
2. Install both V-hooks onto each side of the fixture body (Figure A-2)
3. Connect the V-hooks to the chains with the hooks on each chain. Adjust the height of the installation by locking the chain
hook on the other side of the chain. (Figure A-1)
4. Use the flexible metallic conduit to run the line, neutral and ground wires for powering the fixture. (Figure A-1)
flexible metallic conduit
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
CCT Switch
Fig. A-1
BLACK (LINE)
WHITE (NEUTRAL)
GREEN (GROUND)
PURPLE
PINK
DIM (+) DIM (-)
(DIMMING WIRES TO 0-10V
IEC COMPLIANT CONTROL.)
Fig. A-2
HL3 Series
LED Driver
YELLOW
BROWN
BLUE
AUX+
AUX-
Page: 2
REV: 11/02/22
RED
(-V)
(+V)
Publicité
