Troubleshooting - Danby Premiere DPA110DHA1CP Guide D'utilisation Et D'entretien

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Unit does not work
Unit suddenly stops
during operation
Unit runs intermittently
Unit functions but the
room is not cooled
Condensed water spills
out when moving the unit
Tel: 1-800-26-
POSSIBLE CAUSE
• Power is out
• The plug is not plugged in prop-
erly
• The full-tank indicator is ON; tank
is full
• Current leaking or pressing test
button on LCDI plug
• Indoor set temperature has been
reached
• The preset time is up
• The full-tank indicator is ON; tank
is full
• Malfunction
• Surrounding temperature is too
high/low
• Exhaust duct hose is blocked
• Window or door is open in room
• There is a heat source or too
many people in the room
• Air intake grill is clogged
• Filter is too dirty
• Temperature setting is too high
• The tank is nearly full
14
(1-800-263-2629)
• Wait for power to return
• Plug in properly
• Remove drain water from the
drain tank
• Press the reset button after re-
solving the problem
• Reset the temperature level
• Reset the timer
• Remove drain water from the
drain tank
• Contact your dealer
• This is normal
• Check the duct hose
• Close all windows/doors
• Move any heat sources from
room
• Clean air intake grill
• Replace or clean the fi lter
• Lower temp. setting
• Remove drain plug on rear bot-
tom and drain out water
SOLUTION