Power Outage; Remote Control; Control Buttons - Danby Premiere DPA110DHA1CP Guide D'utilisation Et D'entretien

Operating Instructions

POWER OUTAGE

REMOTE CONTROL

Location of the remote controller
• Use the remote controller within a distance of 8 meters from the appliance, pointing it towards the receiver. Reception
is confi rmed by a beep.
• The air conditioner will not operate if curtains, doors or other materials block the signals from the
remote controller to the indoor unit.
• Prevent any liquid from falling into the remote controller. Do not expose the remote controller to direct
sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not
function properly. Use curtains to prevent the sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either move these appliances or call the
service depot.

Control Buttons

1. Power Switch
2. Mode
3. Fan Speed
4. ON / OFF Timer
5. Time / Temperature Set
• Used for adjusting the timer and temperature.
• The default display on control panel is room temperature.
• When + or - key is pressed in cool mode, the set temperature is displayed and
may be adjusted. After 15 seconds, the display will revert back to room tempera-
ture.
In the case of a power outage or interruption, the unit will automatically re-start with
the default settings after the power is restored.
Wait 3 minutes before resuming operation
After the unit has stopped, it cannot operate for the fi rst 3 minutes. This is to protect
the unit. Operation will automatically start after 3 minutes.
CAUTION
11