Water Drainage - Danby Premiere DPA110DHA1CP Guide D'utilisation Et D'entretien

Operating Instructions

WATER DRAINAGE

1. Drain access water from the tank by placing a pan under the drain water
outlet (Fig. 4).
2. Remove the drain plug and let the water drain into the pan.
3. When the water stops draining out, replace the drain plug.
4. Remove the pan of water.
5. Operate the unit in Fan mode to dry the interior of the unit.
CONTINUOUS DRAIN FUNC-
TION (DEHUMIDIFY)
When using the continuous drain function, the PVC hose must be placed horizontally below the drainage hole. Avoid un-
even ground and folding the hose.
Note: Should you damage or misplace the PVC drain hose, a standard garden hose can be used.
IMPORTANT: The drain hose must be installed during dehumidifi er mode. The function of continuous drain can be
performed using the following steps:
1. To save having to periodically empty the water tank, this unit can be confi gured for continous drain. You can use the
supplied drain hose to connect to the continuous drain connecter.
2. Unscrew and remove the drain cover at the rear of the unit (Fig. 5).
3. Remove the soft rubber stopper, and place it somewhere for safe keeping (Fig. 6).
4. Insert the drain hose through the hole of the drain cover (Fig. 7).
5. Ensure the rubber seal ring is properly seated in the end of the hose as shown in Fig. 7.
6. Connect the drain hose to the drain port (Fig. 8).
7. Tighten the drain cover in a clockwise direction onto the rear of the unit (Fig. 8)
10